LIMA Fish Feed Machine,Chicken Feed Machine
1. Analysis of the difficulties of granulator discharge and low production L44 China Feed Industry Information Network – Based on Feed, Serving Animal Husbandry
1 Used is a new ring mode, First check the compression ratio of the ring mode than whether or not the material is matched, the ring-compression ratio is too large, the particles are too hard, the output is low, that must be re-changing the ring mode compression ratio; L44 China Feed Industry Information Network – Based on the feed, serving the livestock
Smooth, the particles are uneven, and the discharge is difficult, the yield is low, the quality rings must be used; L44 China feed industry information network – based on feed, service animal husbandry
3 such as ring mode use For a while, it must be checked whether the inner wall cone hole is worn, whether the pressure roller is worn, such as the ring-type cone hole wear, the ring mold can be repaired, the pressure roller wear must be replaced, and the ring-shaped tapered hole wear is very large. Impact; L44 China Feed Industry Information Network – Based on Feed, Service Animal Husbandry
4 The ring mode is adjusted correctly, and the spacing is too small to reduce the roller to increase the roller, which will be shortened. When the ring mode is used, the spacing is not smooth, which is not smooth, and the output is lowered; L44 China feed industry information network – based on feed, service animal husbandry
5 pay attention to raw material tuning Time and quality, especially to control the moisture of the raw material insert, the material is generally 12% -13% in front of the injection, and the moisture is left from 14%, such as the high moisture of the raw material, and the temperature of the temperature will be affected. Poor temperament effect, blocking and slippage occurred after the raw material enters ring mode; L44 China Feed Industry Information Network – Based on Feed, Service Animal Husbandry
6 To check the material in the ring Distribution, it is not allowed to run single side, such as a similar situation, must adjust the position of the size feed blade, so that the material is even distributed in the ring mold, which can extend both the ring mode life, while discosing is also smooth. L44 China Feed Industry Information Network – Based on Feed, Serving Animal Husbandry
7 Granulate Machines ldquo; Running, Bearing Running Outlet and other status, will cause granulator work weakness The current is unstable, which is reduced by production. L44 China Feed Industry Information Network – Based on Feed, Serving Animal Husbandry
